MySpool WiFi Alert Board for DIY Sensors, Email & Push Alarm, No Hub

Technical Specifications

• /ALERTS FROM ANY DRY CONTACT SENSOR: Short the two pins on the white connector and this wifi dry contact sensor sends an alert within seconds. Works with float switches, reed switches, door contacts, tilt sensors and any normally-open or normally-closed switch you supply.
• /EMAIL AND PUSH NOTIFICATIONS INCLUDED: Sends to up to 5 email addresses plus push through Pushover or Pushbullet, with no monthly fee for the standard service. Write your own alert wording and add or remove recipients at any time. Native SMS is available through the optional Professional Alert System.
• /NO HUB, NO APP, NO BRIDGE: This wireless sensor alarm joins your 2.4 GHz WiFi network directly and runs on its own. Setup happens once in your phone browser, so there is nothing to install and no gateway, bridge or smart home ecosystem to buy into.
• /SLEEPS UNTIL IT IS NEEDED: The battery powered alarm sensor draws no current between alerts, so 3 AAA batteries (not included) cover over 500 alerts and the practical limit is the shelf life of the batteries rather than any runtime figure.
• /BUILT FOR ROUGH INSTALLS: Sealed enclosure rated to 250 lb and suited to dusty and damp locations. The included JST XH 2.5 mm 2-pin cable can be used as supplied or cut and wired to your own sensor, making this a flexible diy alert board for OEM builds.